The user shall be allowed to use, not to resell, the software by obtaining a license from JVC KENWOOD Corporation.While the media in which the software is stored is possessed by the user, the ownership for the software itself shall be reserved for JVC KENWOOD Corporation.(TM-D710A/E, RC-D710)Adds [EDIT] function on the expanded APRS Message List screen (in function mode).It enables editing of the destination callsign and sentences in received or sent messages and resend.The selection and introduction of the products as well as the results there from shall be upon the liability of the users.JVC KENWOOD Corporation shall own all copyrights and other intellectual properties for the software and all manuals and documents attached to the software.(For APRS status text message sent from other than TM-D710A/E)The quality and performance of the software is not warranted for the applicability of any users.
It then attempts to install other junk software you won’t want.
(TM-D710A/E, RC-D710)When [Menu No.625 : INTERRUPT DISPLAY]-[DISPLAY AREA], is set to [ENTIRE ALWAYS] , "MY POSITION" or "MY MESSAGE" will appear on the interrupted display with the call sign(s) of the digipeater(s).
(TM-D710A/E, RC-D710)When a communications error between the built-in TNC and the operation panel CPU occurs, the built-in TNC will be automatically reset.(To enable the function, please also update the Built-in TNC firmware to Version 1.02.) (TM-D710A/E, RC-D710)Some position packets from the VX-8R/E via IGates might be indicated as "Mic E-MSG" instead of the model name "VX-8".
Setting to "ON (DELAY TIME NONE)" sends an auto-reply message without delay time the same as before updating the firmware.
(TM-D710A/E, RC-D710)Changes the name of the Menu No.624:[APRS]-[SOUND]-[TX BEEP (BEACON)] to [TX BEEP], and enables the output of a beep sound when transmitting an auto-reply message as well as a beacon (position packet).